Skip to main content

VFIO "GPU Passthrough" Guide for Proxmox

BIOS Settings:

  • Disable Above 4G
  • Disable ReBAR
  • Disable SR-IOV (Leave this enabled if using a Quadro or other SR-IOV enabled graphics accelerator)
  • Enable IOMMU Support
  • Enable VT-D
  • Ensure primary output in BIOS is set to iGPU (NOT AUTO)

Proxmox Kernel Version:

  • Ensure Proxmox is running on kernel version 6.0.2 or later -  
    pveversion -v
  • Ensure Proxmox is running on the latest kernel -
  • apt update
apt dist-upgrade
reboot

Proxmox Config:

  • Update the Proxmox Kernel Commandline to boot with IOMMU Support
  • nano /etc/kernel/cmdline
root=ZFS=rpool/ROOT/pve-1 boot=zfs
Change to:
For Intel:
root=ZFS=rpool/ROOT/pve-1 boot=zfs quiet intel_iommu=on
For AMD:
root=ZFS=rpool/ROOT/pve-1 boot=zfs quiet intel_iommu=on
  • Enable IOMMU in Proxmox
  • nano /etc/default/grub
Comment out #GRUB_CMDLINE_LINUX_DEFAULT="quiet"
Replace with
GRUB_CMDLINE_LINUX_DEFAULT="quiet intel_iommu=on" - For Intel
GRUB_CMDLINE_LINUX_DEFAULT="quiet AMD_iommu=on" - For AMD
Save
update-grub
  • Add Kernel Modules
  • nano /etc/modules
vfio
vfio_iommu_type1
vfio_pci
vfio_virqfd
  • Blacklist GPU drivers from loading on root Proxmox (may be needed)
  • nano /etc/modprobe.d/blacklist.conf
blacklist nvidia
blacklist nouveau
blacklist radeon
blacklist amd
  • Ensure your GPU is in a SEPARATE IOMMU  GROUP
  • lspci -v
- Find the group number with your GPU
find /sys/kernel/iommu_groups/ -type l
If you do notice that the GPU you’re using is in the same group as another device, run the command below to attempt to isolate the device then reboot Proxmox and run the steps above again to verify.
echo "options vfio_iommu_type1 allow_unsafe_interrupts=1" > /etc/modprobe.d/iommu_unsafe_interrupts.conf
  • VM Config
  • Boot VM normally and setup Remote Desktop
Shutdown VM
Ensure BIOS Type is set to OVMF (UEFI)
Ensure Memory does not have Ballooning Device enabled
Add the GPU by selecting Add > PCI Device > Select your GPU (Ensure it is the proper IOMMU group as discovered with lspci -v)
Ensure that All fuctions, ROM-bar, Primary GPU, and PCI-Express are all enabled.
Change Display Type to NONE
Log in via Remote Desktop
Install Graphics Card Drivers
RebootReboot.

and Send it.Enjoy.
Back to top